Filter
Top Products
GB - 10
UNIT ASSEMBLY
Package Contents:
Unit, Mower Deck and Literature Pack
Preparation Checklist
Refer to the Owner/Operator manual as
required.
1. Unpack Unit - Remove shrink wrap and
packaging materials.
2. Remove Unit From Container - Open
Bypass Valves (dump valves) (See
Moving the Unit with the Engine Off on
page 16).
Push unit from container onto a level
surface. Close the bypass valves.
3. Tires - See Specifications on page 31.
4. Seat - See Seat Adjustments on
page 13 and Service Position on
page 18.
5. Position Steering Levers - Remove
eccentric spacers and rotate steering
levers to the operating position. Reinstall
spacers. Tighten hardware securely.
See Aligning the Steering Levers
(Figure 14) on page 23.
6. Battery - Remove battery from unit and
charge (See Battery on page 21).
7. Check Engine Crankcase - Check and
add oil if needed. See Engine Manual for
specifications.
8. Fill Engine Fuel Tank - Fill fuel tank. DO
NOT OVERFILL! See Filling Fuel Tank
on page 14.
NOTE: See engine manual for fuel type.
9. Hardware - Check for loose hardware.
ASSEMBLY
WARNING: AVOID INJURY.
Read and understand entire
Safety section before proceeding.
CAUTION: Avoid injury! Explosive
separation of tire and rim parts is
possible when they are serviced
incorrectly:
• Do not attempt to mount a
tire without the proper
equipment and experience
to perform the job.
• Do not inflate the tires
above the recommended
pressure.
• Do not weld or heat a wheel
and tire assembly. Heat can
cause an increase in air
pressure resulting in an
explosion. Welding can
structurally weaken or
deform the wheel.
• Do not stand in front or over
the tire assembly when
inflating. Use a clip-on
chuck and extension hose
long enough to allow you to
stand to one side.
1. Steering
Levers
2. Seat
3. Mounting
Hardware
OF4110
Figure 3
1
3
2
1