Filter
Top Products
GB - 15
Throttle Lever
The throttle lever changes
the engine speed. Move
the throttle lever to Fast (1)
to increase engine speed.
Move the lever to Slow (2)
to decrease engine speed.
Bypass Valve Lever
Pull the lever back to set
the pump in neutral and
move the unit with the
engine off.
Push the lever in to set the
pump in the drive position
and operate the unit.
Power Take Off (PTO)
Switch
Power take off (PTO)
switch engages and
disengages the mower
blades.
Pull the power take off
(PTO) switch to "On"
position to engage mower
blades.
Push the power take off
(PTO) switch to "Off" position to disengage
mower blades.
NOTE: The engine will not start unless the
steering control levers are in the neutral
position, the PTO switch is in the “Off”
position and parking brake is set.
Mower Lift Pedal
Mower lift pedal raises and lowers mower
deck for mowing or transport.
Transport:
Push mower lift pedal all the way forward until
lift lock engages.
Cutting Height:
Put cutting height adjustment pin in desired
hole. Push mower lift pedal forward and hold
it while pushing down on the lift lock. Slowly
lower mower lift pedal until deck lift contacts
cutting height adjustment pin.
Parking Brake Lever
1. Pull lever up to engage
parking brake.
2. Push lever down to
disengage parking brake.
Seat Adjustments
To adjust seat forward or backward:
1. While seated, pull seat adjustment lever
outward and slide seat into desired
position.
2. Release lever and slide seat forward or
back to lock seat into position.
Hour Meter
Press and release the toggle button to shift
between different functions.
Press and hold the toggle button to reset the
timer or clear a service message.
The hour meter has three functions:
Hour Meter: measures the amount of time
the engine has been run. This time cannot be
cleared.
Timer (TMR1): measures the time spent on
individual jobs.
Press and hold the toggle button to reset the
timer to zero. TMR1 will then start measuring
engine run time until it is reset to zero again.
Service Alert (Chg Oil, Chg H Oil & Filter,
SVC Airfilter): reminds operators of the
maintenance interval for changing the engine
oil, changing the hydraulic oil and filter and
servicing the air filter.
The alert starts counting down two hours
before the maintenance is due. The meter
flashes the word, "Now," when it reaches the
maintenance time.
Press and hold the toggle button to reset the
maintenance clock to zero after perfoming
the service.
OF1700
2
1
Drive
Neutral
OE0261
OFF
ON
OF1700
WARNING: Make all seat
adjustments with unit stationary,
parking brake on and engine shut
off.
OF1740