Filter
Top Products
GB - 14
IMPORTANT: Proper maintenance can
prolong the life of unit. The following chart
shows the recommended service schedule.
Refer to the maintenance instructions in the
Engine Manual for additional information.
MAINTENANCE SCHEDULE
WARNING: AVOID INJURY.
Read and understand the entire
Safety section before
proceeding.
Interval Task Action
Each
Use
Check Safety
Interlock System
WARNING: Safety interlock system failure and
improper operation of unit can result in death or
serious injury. Test this system each time the unit
is operated. If this system does not function as
described, do not operate until repairs are made.
See Operator Presence Control on page 9.
Clean Unit Remove all dirt, grease, leaves, etc.
Check Tires Make sure the tires are positioned correctly for the
intended job and are securely fastened. See Make sure
the front wheel does not contact the blade when angling
the blade for a beveled edge. on page 10 and Front Wheel
Adjuster on page 10.
Check Edger Blade
and Mounting
Hardware
Make sure the blade is free of nicks, broken ends, thinned
metal or other damage. Make sure the hardware is
tightened to 30 – 62 lbf-ft. (40.7 – 84.0 N•m). See Blade
Change on page 15.
Check Guards and
Mounting Hardware
Make sure all guards are securely fastened and are in
good repair.
Check Engine Oil
Level
Check the engine oil level according to instructions
provided in the engine owner’s manual.
Check Engine Air
Filter
Check the engine air filter for dirt and debris according to
instructions provided in the engine owner’s manual. Clean
or replace as needed.
25 Hours
or Every
Season
Lubrication Apply a light oil to the pivot shaft and all sliding joints, to
the front axle shaft and to the wheel bushings.
Change engine oil according to instruction provided in the
engine owner’s manual.
50 Hours
or Every
Season
Check Belt Check the belt for cuts, nicks or abrasions. Replace worn
or damaged belts. See Belt Change on page 15.
Check Spindle
Bearings
Check the spindle bearings for wear or damage. Replace
as needed.