Filter
Top Products
GB - 8
Keep the nozzle in contact with the rim of the fuel tank or
container opening at all times until fueling is complete.
Do not use a nozzle lock-open device.
If fuel is spilled on clothing, change clothing immediately.
Battery posts, terminals and related accessories contain
lead and lead compounds, chemicals known to the State
of California to cause cancer and reproductive harm.
Wash hands after handling.
Reverse connections may cause sparks which may result
in injury. ALWAYS connect/disconnect cables in proper
order.
Poisonous battery fluid contains sulfuric acid and its
contact with skin, eyes, or clothing can cause severe
burns.
Explosive Gases! No flames, No sparks, No smoking
near battery.
ALWAYS wear safety glasses and protective gear near
battery.
DO NOT TIP battery beyond a 45° angle in any direction.
ALWAYS keep batteries out of reach of children.
Before making any inspections, repairs, etc.: disengage
PTO, stop unit and engine, remove key, allow moving
parts to stop.
Allow hot parts to cool.
ALWAYS block wheels, engage parking brake and know
all jack stands are strong, secure and will hold weight of
unit during maintenance.
An extension spring, when extended, stores energy and
can be dangerous. Always use tools specifically designed
for installing or removing an extension spring. Always
compress or extend springs slowly.
ALWAYS maintain unit in safe operating condition.
Damaged or worn out muffler can cause fire or explosion.
Keep hardware, especially blade attachment bolts, tight.
Maintain or replace safety and instruction labels, as
necessary.
For unit storage or extended storage:
• NEVER store with fuel in fuel tank, inside a building
where any ignition sources are present.
• Allow engine to cool completely.
Use only attachments or accessories designed for your
unit.
Check attachment components frequently. If worn or
damaged, replace with manufacturer’s recommended
parts.
Use extra care with grass catchers and other
attachments. These can change the stability of the unit.
Use only approved hitch points.
ALWAYS be aware of attachments when turning.
ALWAYS allow adequate clearance between
attachments, personnel, and other objects.
TOOLS REQUIRED
Phillips Screwdriver, Needle Nose Pliers, Open-End
Wrench: 3/8, 7/16, 9/16 & 3/4 and/or Adjustable Wrench
REMOVE UNIT FROM CARTON
Remove the unit and components from the shipping
container.
ASSEMBLY
WARNING:
AVOID INJURY. Read and
understand entire
Safety
section before
proceeding.
Figure 4
Handlebar
Assembly
Fwd-Rev
Control
Rod
Hi-Lo
Control Rod
Tractor
Assembly
Optional
Brake Handle
Assembly
Brake Rod, RH
Brake Rod, LH
DH0010