Filter
Top Products
GB - 12
Throttle Lever
The throttle lever is used to control the engine
speed. To increase the engine speed, move
the lever up to the “FAST” position. To
decrease the engine speed, move the lever
down to the “SLOW” position.
Choke Control
The choke control is used to choke a cold
engine for starting. The choke control is
located on the instrument panel. On 8.5HP,
12HP and 13.5HP tractors, push the choke
lever up to the “ON” position to choke the engine. On all
other tractors, pull the choke control knob out to the “ON”
position to choke the engine.
PTO Control
The PTO control is used to connect or
disconnect the engine power to an
attachment. The forward position is “OFF”;
the rearward position is “ON”.
Ignition Switch
The ignition switch is used to start (electric
start models) and stop the engine.
Hourmeter
The hourmeter shows total time which the ignition switch
has been in the “ON” position.
Fuse
Electric start models have a fuse to protect the electrical
system.
Kick Stand
The kick stand is used to hold the tractor level when there
is no attachment on the tractor. The kick stand must be in
the raised position when moving the tractor.
Brake Handlebar
On tractors with steering brakes, the brake handlebar is
used to steer the tractor. Swing the brake handlebar left
for a right turn or right for a left turn.
Parking Brake (optional on 985115)
The parking brake is used to hold the tractor in position
when not in use.
FILL FUEL TANK
Add fuel to the fuel tank as needed. See engine manual
for the correct type and grade of fuel.
1. Put the unit in an open area.
2. Stop the engine and lock the brake.
3. Clean the fuel cap and the area around the fuel cap
to prevent dirt from entering the fuel tank.
4. Remove the cap from the fuel tank.
5. Fill the fuel tank. Be careful not to spill the fuel.
6. Install the cap on the fuel tank and tighten.
7. Clean up any spilled fuel before starting the engine.
TO STOP IN AN EMERGENCY
1. Turn the ignition key to "Off".
2. Move the HI/LO to the “NEUTRAL” position and the
PTO control to the “OFF” position.
3. Wait for all moving parts to stop before leaving the
operator’s position.
TO START AND SHUT OFF ENGINE
Manual Start
1. Check each item in "Before Each Use" in the
Maintenance Schedule.
2. Move the direction control lever to the “NEUTRAL”
position.
3. Ensure the PTO control is in the “OFF” position and
the gear shift lever is in the “NEUTRAL” position.
4. Put the key in the ignition switch and turn it to the
“ON” position.
5. If the engine is cold, apply the choke. See Engine
Manual for detailed instructions.
6. Set the throttle to the proper starting position. After
the engine starts, adjust the choke as needed.
7. Pull the starter handle out until compression is felt
in the engine. Then pull with one swift continuous
motion. Hold the starter handle to allow a slow
rewind of the rope.
8. If the engine does not start after six pulls of the
starter, see Troubleshooting.
Electric Start Engine
1. Check each item in "Before Each Use" in the
Maintenance Schedule.
2. Move the direction control lever to the “NEUTRAL”
position.
WARNING: Never move the range shift
handle while on a slope or while the tractor
is moving. Move the handle only when the
tractor is on level ground and stopped
(except for rocking to engage the clutch as
described above).
STOP
START
RUN
WARNING: Use caution with fuel. Fuel is
very flammable. Keep fuel in a clean and
tight container. Keep fuel away from fire or
heat. Never put fuel in the fuel tank while
the engine is running or hot. Clean up any
spilled fuel before starting the engine.