Filter
Top Products
GB - 14
SWIVEL HEAD ADJUSTMENT
(Figure 9)
1. Stop the engine and wait for all moving
parts to stop. Disconnect the spark plug
wire and place it securely away from the
spark plug.
2. Loosen the wing knob on the bracket at
the rear of the unit.
3. Rotate the back of the unit in the opposite
direction of the side you wish to cut with.
4. Tighten wing knob securely.
CONTROL BAIL TRAVEL
ADJUSTMENT
(Figure 10)
Control Bail must disengage trimmer head as
control is released. There should be a slight
amount of slack in the control cable wire when
bail is fully released. If the trimmer head does
not disengage completely when the control
bail is released, increase the amount of slack
in the control cable wire as follows:
1. Loosen the bottom cable nut.
2. Push the cable conduit upward toward the
control bail.
3. Tighten the upper cable nut onto the
mounting bracket to lock the conduit in
place.
4. Turn nuts against mount to lock in
position.
DRIVE BELT REPLACEMENT
(Figure 11 & 12)
Wing Knob
OX5055
Figure 9
1. Control Cable
2. Control Cable
Wire
3. Control Bail
4. Handlebar
5. Cable Nuts
6. Cable Conduit
2
4
5
1
OX5050
3
6
Figure 10
1. Six hex washer
head screws
2. Trimmer shield
3. Four hex
washer head
screws
4. Trimmer frame
5. Jackshaft
assembly
6. Jackshaft
spacers
7. Jackshaft
pulley belt
fingers
8. V-belt
9. Jackshaft
pulley
10.Engine sheave
11.Capscrew
12.Lock washer
13.Engine sheave
belt fingers
OX5065
Figure 11
1
2
3
4
5
6
7
8
9
1
1
11
12
13
10