Filter
Top Products
GB - 16
3. Loosen belt finger and rotate until there
is 1/32 – 1/16 in. (0.8 – 1.6 mm) gap
between belt finger and drive belt.
4. Tighten belt finger.
5. Recheck gap between belt finger and
drive belt. Adjust belt finger until there is
1/32 – 1/16 in. (0.8 – 1.6 mm) gap
between belt finger and drive belt.
6. Go to Check Auger Stopping Time next.
Check Auger Stopping Time
1. Start unit.
2. Engage auger clutch bail for 5 seconds.
IMPORTANT: Auger MUST STOP within 5
seconds of disengaging auger clutch bail.
3. Disengage auger clutch bail.
• If auger stops within 5 seconds, the
adjustment is complete.
• If auger does not stop within 5
seconds, repeat the entire Drive Belt
Adjustment procedure.
IMPORTANT: Replace the drive belt if the
Drive Belt Adjustment procedure has been
completed twice and the drive belt is still not
adjusted properly.
4. Replace cowl.
WARNING: Improper adjustment
could result in death or serious injury.
Auger brake MUST DISENGAGE
when clutch is engaged. Auger brake
MUST STOP AUGER WITHIN 5
SECONDS of releasing auger clutch
bail.
WARNING: ROTATING PARTS can
cut off body parts. Keep hands and
feet away. Loose clothing, long hair
or scarves can get caught in rotating
parts and cause death or serious
injury.
WARNING: Auger MUST NOT rotate
when the auger clutch bail is
disengaged.
Figure 12
OS4501
1.Idler
2.Idler Nut
3.Belt Finger
4.Drive Belt
3
2
1
3
1/32 – 1/16 in.
(0.8 – 1.6 mm)
4
4