Filter
Top Products
GB - 16
UNIT
Run with auger clutch engaged a few minutes after
each use to free unit of any loose or melting snow.
Inspect unit for visible signs of wear, breakage or
damage. Order any parts required and make
necessary repairs to avoid delays when beginning use
again.
Keep all nuts, bolts and screws properly tightened and
know unit is in safe working condition.
ENGINE
When storing unit for extended periods of time, remove
all fuel from tank and carburetor (run dry). Refer to
Engine Manual.
WARNING: FLAMMABLE FUEL and its
EXPLOSIVE VAPORS can cause death or
serious injury. DO NOT store unit inside a
building with fuel in the fuel tank where any
ignition sources are present. Drain fuel
outdoors away from any ignition source. Allow
engine to cool before storing in any enclosure.
Only use approved fuel containers.
PROBLEM PROBABLE CAUSE CORRECTION
Engine will
not crank
1. Ignition switch not in "RUN" position.
2. Bad starter or wire connection.
3. Electrical problem
1. Turn key to "RUN" position.
2. Check connections. See your Dealer.
3. Check wiring for wear, damage or poor
connections. See your Dealer.
Engine will
not start
1. Ignition switch not in "RUN" position.
2. Bad starter or wire connection.
3. Engine ignition problem.
4. Fuel tank is empty.
1. Turn key to "RUN" position.
2. Check connections. See your Dealer.
3. See Engine Manual.
4. Fill tank with properly mixed fuel. Prime
engine, set choke for easier start.
Engine stops
1. Improperly mixed or contaminated
fuel.
2. No spark.
1. Use only clean, properly mixed fuel. If
necessary, drain tank and refill with new fuel
mixture.
2. Check spark plug and connecting wire.
Discharge
chute will not
turn
1. Chute gears are frozen. 1. Move unit to a warm area to thaw.
Auger will not
turn or throw
snow
1. Auger is frozen in place.
2. Ice or debris is obstructing auger.
3. Auger control cable out of
adjustment
4. Drive belt slipping; idler out of
adjustment.
1. Move unit to a warm area to thaw.
2. With engine off, and auger disengaged,
check for obstructions and remove.
3. Adjust cable. See Service and Adjustments.
4. Adjust idler. See Service and Adjustments.
STORAGE
TROUBLESHOOTING