Filter
Top Products
GB - 23
Replace Attachment Drive Belt
1. Place new belt onto lower pulley and
while holding brake out of way, tip unit
together.
2. Secure blower housing to frame with cap
screws.
3. Place belt onto engine sheave.
4. Make sure engine sheave and attachment
pulley align. If alignment is necessary,
loosen engine sheave set screws,
reposition sheave and retighten set
screws.
5. Replace belt finger.
IMPORTANT: BELT FINGER MUST BE
between 1/16 to 1/8 in (1.6–3 mm) from belt
with attachment clutch engaged or belt
grabbing may occur causing impeller to rotate
while attachment clutch is disengaged
(Figure 15).
6. Adjust clutch per Attachment Clutch/
Impeller Brake Adjustment below.
7. Reinstall chute strap and mounting
hardware onto engine.
8. Replace chute crank and secure with
spring pin.
9. Replace belt cover and secure with
screws.
OS0802
1
2
3
4
5
6
7
8
9
Figure 14
1.Pinion and Gear
2.Spring Clip Pin
3.Chute Crank
4.Chute Strap
5.Chute Strap Mounting Hardware
6.Housing Bolt Holes
7.Bottom Cover
8.Belt Cover
9.Universal Joint
OS0464
1
2
3
4
5
6
7
Figure 15
8
1.Attachment Belt Idler
2.Belt Finger
3.Attachment Drive Belt
4.Traction Drive Belt
5.Camshaft Pulley
6.Engine Sheave
7.Traction Belt Idler
8.Attachment Pulley
9.Attachment Idler Nut
9