Filter
Top Products
GB - 25
8. Check belt finger clearance.
With clutch lever engaged, belt fingers
should be 1/16–1/8 in (1.6-3 mm) from
belt. Adjust belt fingers as necessary.
9. Replace belt cover.
10. Check that auger/impeller stops within
3 seconds after attachment clutch/
impeller brake bail is released.
TRACTION DRIVE CLUTCH
ADJUSTMENT
If drive slips, adjust traction clutch to
compensate for friction disc wear.
To test traction clutch (Figure 17):
1. Put unit in first forward speed.
2. Without engine running, push unit forward
while slowly moving the traction drive
clutch lever toward the handle grip.
3. Measure distance between lever and
handlebar when the wheels brake. If
distance is not 6–1/8 in ± 1/4 in
(15.5 cm ± 6 mm), adjust the traction
clutch.
To adjust traction clutch (Figure 18):
1. Loosen jam nut on traction cable
adjustment barrel.
2. Turn the adjustment barrel up the cable to
decrease the distance between clutch
lever and handlebar.
Turn the adjustment barrel down the cable
to increase the distance between clutch
lever and handlebar.
3. Check traction clutch lever distance and
repeat adjustment steps if necessary.
4. Tighten jam nut on traction cable
adjustment barrel.
Figure 16
OS2030
1/16 in
(1,6 mm)
2
1
1.Drive Belt
2.Brake Shoe and Pad
4-1/2 ± 1/8 in
6-1/8 ± 1/4 in
(15,5 cm ± 6 mm)
(11,43 cm ± 3 mm)
Figure 17
Traction Drive
Clutch Lever
Attachment
Clutch Lever
OS0456
Figure 18
1.Traction Clutch Cable
2.Shift Rod
3.Attachment Control Cable
4.Mounting Nuts
5.Attachment Clutch Arm
6.Speed Selector Arm
7.Cotter Pin and Clevis
8.Traction Drive Clutch Arm
9.Adjustment Barrel
OS0522
1
2
3
4
5
6
7
8
9