Filter
Top Products
Page 4 of 4
Date: Jul. 22, 2011 No. B-2078
7. Install drive belt and accessory belts (Figure 6).
8. Install belt finger (B) and retain with hardware removed earlier (Figure 6). Torque to 132 lbf-in.
9. Ensure proper belt finger clearance:
• With attachment clutch engaged belt finger on the side opposite the belt idler should have a maximum
clearance of .125” from belt without touching.
10. Replace belt cover.
Remove Protective Cover From Recoil Housing
1. Remove the plastic protective covering from the recoil housing. Engine overheating and potential
damage can occur if left in place.
Figure 6
B
Figure 7