Filter
Top Products
Page 3 of 4
Date: Jul. 22, 2011 No. B-2078
Engine Mounting Hardware
1. Remove four hex nuts retaining engine to Sno-Thro frame. Note position of cable J-hook for
reinstallation. Discard hex nuts but retain J-hook.
2. Install two silver thin-wall bushings (Item 3) over rear studs and slide down into engine base
(Figure 4).
3. Install two gold thick-wall bushings (Item 4) over front studs and slide down into engine base
(Figure 4).
4. Install two 5/16 locking top flange nuts (Item 1) on rear engine mounting studs. Do not fully tighten
(Figure 5).
5. Install two 3/8 flat washers (Item 2) and two 5/16 locking top flange nuts (Item 1) on front engine
mounting studs (Figure 5).
NOTE: Ensure that J-clip for chute deflector cable is correctly repositioned.
6. Tighten all engine-mounting hardware to 135 lbf-in.
Figure 4
3
4
Figure 5
2
1
1
F
r
o
n
t
F
r
o
n
t