Filter
Top Products
Step Three: Install
Discharge Chute Crank
1. Remove the gear cover from top of chute pedestal.
2. Insert the short end of the chute crank into the hole in the front
of the control panel.
NOTE: Be careful not to damage nylon bushing when attaching
crank to the dash.
3. Connect the chute crank to the pinion gear on chute with
hairpin.
4. Replace gear cover on top of chute pedestal.
5. Orient the chute and pedestal to its most vertical position and
tighten pedestal hardware to 15 – 31 lbf-ft (20 – 42 N•m).