Ariens 921005 - ST927LE Snow Blower User Manual


 
GB - 18
Discharge Chute
Discharge chute rotates 200°.
ALWAYS position discharge chute in safe
direction and angle, away from operator and
bystanders, before starting engine.
Discharge Chute Control (921004,
006, 007, 008, 009)
IMPORTANT: If chute does not stay in set
position, adjust as directed in SERVICE AND
ADJUSTMENTS on page 24, or repair before
operation.
Rotate the Chute with Discharge Chute
Control.
IMPORTANT: DO NOT force frozen chute
controls. If frozen, take to warm place until
controls are free.
Discharge Chute Crank (921005)
IMPORTANT: If chute does not stay in set
position, adjust as directed in SERVICE AND
ADJUSTMENTS on page 24, or repair before
operation.
Rotate the Chute with Discharge Chute
Crank.
IMPORTANT: DO NOT force frozen chute
controls. If frozen, take to warm place until
controls are free.
Remote Wheel Lock (921005)
Squeeze and release the remote wheel lock
control to lock the left wheel for better traction
when throwing snow or to unlock the left
wheel for easier steering.
NOTE: The wheel lock will not release when
under load. Do not unlock the wheel while
turning. If the wheel lock will not release, turn
the unit slightly left or right to relieve axle load
and release the axle lock.
If remote wheel lock does not lock or unlock
properly, adjust or repair before operation
(see Remote Wheel Lock (921005) on
page 25).
Scraper Blade
The scraper blade allows the back of the
housing to keep better contact with the
surface being cleared. It also prevents
damage to the housing from normal wear.
IMPORTANT: DO NOT allow Scraper Blade
to wear too far or Auger/Impeller housing will
become damaged.
Runners
The runners control the distance between the
scraper blade and the ground. Adjust runners
equally to keep blade level with the ground.
Refer to Pre-Start on page 19 for
recommended settings.
Figure 16
OS7103
1
1. Deflector Handle
921005
Figure 17
OS7105
921004, 006, 007, 008, 009
Figure 18
OS7106
921005