Filter
Top Products
EN - 14
Front Stand (Item 6)
Front stand must be locked in the down
position whenever the unit is in use and in the
transport position when moving or towing the
unit.
(Figure 9)
1. Remove hair pin from clevis pin and
remove clevis pin from tongue bracket.
2. Rotate stand up or down until the top
edge of the handle on the stand aligns
with the upper or lower notch in the
tongue bracket.
3. Insert clevis pin into tongue bracket and
insert hair pin.
Rear Stabilizer (Item 12)
(Figure 10)
Rear stabilizer must be positioned down and
locked in place when operating in the
horizontal position.
1. Remove hair pin from upper lock pin and
slide lock pin out from brackets.
2. Rotate rear stabilizer down until holes in
stabilizer align with holes in brackets.
3. Insert lock pin all the way through
brackets and stabilizer.
4. Reinstall hair pin.
IMPORTANT: Rear stabilizer must be locked
in the transport position before towing unit or
before placing beam in vertical operating
position.
OPERATION
FILLING FUEL TANK
To add fuel to the fuel tank:
1. Clean fuel caps and surrounding area to
prevent dust, dirt, and debris from
entering fuel tanks.
2. Remove fuel caps.
IMPORTANT: Refer to Engine Manual for
correct type and grade of fuel.
3. Fill fuel tank to the bottom of filler neck.
See
SPECIFICATIONS on page 22 for
fuel tank capacity.
CAUTION: Front stand must be
locked in the transport position
before towing the unit.
Figure 9
Remove hair
pin and clevis
pin and rotate
stand up or
down.
Reinstall clevis
pin and hair pin.
Notch
Figure 10
Remove hair
pin and slide
lock pin out.
Insert lock pin
through
brackets and
insert hair pin.
Transport Position
Work Position