Filter
Top Products
Page 2 of 2
Date: July 17, 2009 No. B-2048
Remove and discard the two 3/8 bolts
and top locking flange nuts closest to
the cylinder.
NOTE: Stroke the cylinder slightly for-
ward to get access to the bolts. Shut
down the log splitter after stroking the
cylinder. DO NOT replace the bolts
while the unit is running.
Use a 1/2” drill bit to bore out
the mounting holes closest to
the cylinder.
Install .50-13 x 2 Grade 8 hex bolt
(p/n 05970700), .563 x 1.38 x .109
flat steel washer (p/n 06442000),
and .50-13 center lock
nut (p/n 06536300). Tighten to
50 lbf-ft (67.8 N•m).
Cylinder
Wedge
.50-13 x 2 Grade 8 hex
bolt (p/n 05970700)
.563 x 1.38 x .109 flat steel
washer (p/n 06442000)
.50-13 center lock nut
(p/n 06536300)