Filter
Top Products
GB - 22
IMPORTANT: NEVER spray unit with high-
pressure water or store unit outdoors. Store
mower in a cool, dry, protected location.
Cleaning
Clean unit thoroughly with mild soap and low
pressure water. Brush off dirt and debris from
all surfaces. Touch up all scratched surfaces
to prevent rust. Matching touch-up paint is
available from your Ariens Dealer. Do not use
abrasives, solvents, or harsh cleaners.
Inspection
Inspect mower and repair or replace worn or
damaged parts to avoid delays when
beginning use again.
Regularly check all hardware and keep
fasteners tight. Know unit is in safe working
condition.
Grass Bag
Wash out grass bag and allow to dry before
storage. Grass bag may be stored in position
on mower.
Engine
Close fuel shutoff valve (911102, 141).
When storing unit for extended periods of
time, remove all fuel from tank and carburetor
(run dry). Refer to engine manual.
STORAGE
CAUTION: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
TROUBLESHOOTING
PROBLEM PROBABLE CAUSE CORRECTION
Engine will not
start
1. Fuel tank empty or low.
2. Fuel shutoff valve closed.
3. Spark plug wire loose or off.
4. Throttle control not in proper
position.
5. Engine/Blade control cable
detached, broken, or not
adjusted properly.
1. Check fuel level. Fill tank if
necessary.
2. Open fuel shutoff valve.
3. Check connection.
4. Adjust throttle to FAST
position.
5. Check cable. Adjust, repair
or replace as necessary.
Engine is
difficult to
restart
1. Mower clogged with grass. 1. Clear clippings from under
mower. (Allow the mower to
clear clippings before
shutting off engine.)
Cut is poor
1. Worn blade.
2. Too much grass is being
removed per cutting.
3. Grass is too wet.
4. Mowing speed is too fast.
1. Check blade (see CHECK
MOWER BLADE on
page 15).
2. Raise cutting height.
3. Allow grass to dry.
4. Mow slower.
Grass does
not disperse
evenly
1. Too much grass is being
removed per cutting.
2. Grass is too wet.
3. Mowing speed is too fast.
1. Raise cutting height.
2. Allow grass to dry.
3. Mow slower.
Mower does
not bag
clippings
1. Grass bag is overfilled.
2. Mulching plug is installed.
1. Empty grass bag and do not
allow it to overfill.
2. Remove mulching plug.