Filter
Top Products
GB - 11
CONTROLS AND FEATURES
See Figure 6 for locations.
Engine/Blade Control
The engine/blade control must be held
against the handlebar to start the engine and
blade.
NOTE: For models 911112, 113 pivot the
engine/blade control into position. Do not pull
back toward the operator while starting the
engine or the wheel drive may engage.
Engine/blade control feature on mower stops
engine and blade within 3 seconds whenever
operator releases handlebar. Check this
feature frequently. If feature fails to operate,
disconnect spark plug wire and adjust or have
it repaired before using unit.
Handlebar
Adjust handlebar to a safe and comfortable
height. See HANDLEBAR HEIGHT on
page 19.
Recoil Starter Handle
When pulled, handle will turn engine over.
CUTTING HEIGHT ADJUSTMENT
OPERATION
WARNING: Improper operation
can lead to injury. Learn what the
controls do and how they work.
Thoroughly read and understand
entire Operator Manual.
CAUTION: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
CAUTION: Check function of
Engine/Blade Control regularly.
Improper function of control could
cause injury.
STOP START and RUN
OM1230
911110, 111
DANGER: Avoid injury from
rotating blade.
ALWAYS shut off engine before
adjusting cutting height.
CAUTION: On self-propelled
models, both rear wheels must be
set at same height or traction drive
may not work properly.
911112, 113
STOP
START and RUN