Filter
Top Products
Lock Pin
CLEANING PATTERNS
FIG.9
ADJUSTING THE Jet Cleaner FOR YOUR POOL
The Jet Cleaner uses a systematic cleaning pattern that allows the cleaner to go back and fourth in
overlapping patterns. The Jet Cleaner may be used to clean a variety of different size pools, from the
small, to the very large. Before its first use, you must set up the Jet Cleaner for your pool. To adjust the
Jet Cleaner you will use the axle locking pin. (Fig. 10). There are two locking pins permanently
attached to the unit with a lanyard. Only one locking pin is required for most applications. For the very
large pools you will need to install an additional locking pin (Located on the jet valve housing). Follow
the pin configuration illustration for your size pool (Fig. 11).
OTHER CLEANING PATTERNS
If you feel that the Jet Cleaner is not
cleaning your entire pool, you may wish
to make one of the following adjustments
to its cleaning pattern:
SETTING THE CLEANING PATTERN
FOR YOUR POOL
Your Jet Cleaner is pre-set to scan and
clean most pools 70 to 80 feet (20 to 24
meters) in length. The Jet Cleaner is
factory set to look like the picture in Fig. 9
with one Lock pin installed on each side.
The Jet Cleaner will systematically clean
your pool in a consistent pattern.
After your Jet Cleaner completes its
cleaning cycle remove the Jet Cleaner
from the pool and transfer the Lock pins
from the right side of the unit to the left
side(vice versa). Next time you use your
Jet Cleaner the cleaning unit will clean
the pool in the opposite pattern. This will
ensure that your cleaner completely
cleans your entire pool.
FIG.10
6