Filter
Top Products
-10-
Cleaning and Replacement
1. As a general rule, the filter cartridge in your pump filter system
should be replaced approximately once per month. This will vary
depending on usage hours by bathers, number of bathers, and the
amount of time the filter system is run without bathers on a daily
basis.
2. In between replacing filter cartridges, periodically cleaning of
your filter cartridge can enhance the effectiveness of your filter
pump and moderately prolong the cartridge's lifespan prior to
replacement.
3. In order to clean your filter cartridge, you must first disconnect
power to the unit in order to avoid dangerous or fatal electric
shock hazard.
4. Remove the Strainers (P35) inside of the pool, and close the caps
of the pool Wall Plugs (P34).
5. Turn the Air Valve Cover (P1) in a counter-clockwise direction to
release the air suction inside.
6. Remove the Filter Chamber Cover (P4) of filter pump in a
counter-clockwise direction.
7. Remove the filter chamber Rubber Gasket (P5).
8. Take out the filter cartridge (P6).
9. Clean the filter cartridge with a garden hose using a direct
powerful waterspray.
10. If the filter cartridge cannot be cleaned effectively in this maner, it
is time to replace it with a new cartridge.
11. Your clean (or new) cartridge can now be put back into the filter
chamber and you can refer to the installation instructions on page
6 to re-assemble the filter pump unit.