Filter
Top Products
3
lens of the IR
main body of IR
lock ring
cap
thread
thumb screw
OPERATION
• Take the monocular out of the case.
• Install the batteries into the housing with the polarity order as shown on the scope. Battery
Type: 3 Volt Lithium, #CR123A
• Press Button marked –/O to turn unit on with the protective lens cover still attached to the
lens. Do not turn unit on in the daytime without the protective lens cap on. You should
see a green glow in the eyepiece
• Observe the scene, and adjust the diopter for optimal image clarity.
• You may now enter a dark environment, or simply shut the lights off in order to darken the
room.
• Next, remove the lens cap/daylight filter. Adjust front lens for distance focus. You should not
have to readjust diopter.
• You will need to focus the objective lens for different distances.
LONG-RANGE INFRA-RED ILLUMINATOR
The long range IR works on a separate battery from the main unit. To install the battery
unscrew cap and insert battery in the same direction as depicted by the diagram on the IR. To
install the long range IR to the main body of the Patriot screw the thumb screw on the IR into
the thread on the body of the Patriot.
You may notice that IR might not shine directly in the middle of your viewing image. This can be
adjusted by unscrewing the lock ring, then adjusting the main body of IR. Once you have the IR
aimed in the correct direction re-tighten locking ring. You may desire a different field of coverage
from the IR illuminator. If so the beam is focusable. By turning the lens of the IR you will change
the beam width slightly.