American Standard T6280 Outdoor Shower User Manual


  Open as PDF
of 3
 
2
Remove HANDLE and TRIM. See step one and reverse assembly procedure.
TO GAIN ACCESS TO VALVE FOR SERVICING
Remove CARTRIDGE (1) by removing CARTRIDGE SCREWS (2). Remove three SCREWS (3) from FIXATION RING (4) and
pull out PRESSURE BALANCING (5) unit.
Clean SEALS (9) on base of CARTRIDGE (1). Check base of PRESSURE BALANCING UNIT (5) and clean O-RINGS (6). Remove
CAPS (7) and check O-RINGS on inside of CAPS (7) for debris. Clean inside sealing surfaces of VALVE BODY (8).
Reassemble PRESSURE BALANCING UNIT (5) and CARTRIDGE (1). Tighten all screws.
Turn on water supply. If it still leaks, replace pressure balancing unit (M952100-0070A). See step one for installing
TRIM and HANDLE.
VALVE LEAKS WHEN SHUT OFF
Remove PRESSURE BALANCE UNIT (5).
Remove CAPS (7) and clean valve thoroughly.
Examine balancing unit and check condition of O-ring on end of piston. Piston should move back and forth. Order Repair
Part M952100-0070A if balancing unit is defective.
Replace CAPS (7) and install PRESSURE BALANCE UNIT (5). Make sure inlets line up with two holes in bottom of casting.
Top flange should butt-up against top of casting.
UNABLE TO MAINTAIN CONSTANT TEMPERATURE
M968289
TEST INSTALLED FITTING
4
Turn VALVE (1) "off".
With HANDLE (2) in "off" position, turn
on water supplies and check all connections
for leaks.
Operate HANDLE (2) and flush water
lines thoroughly. Pull DIVERTER (3) up
and check SHOWER (4) for proper
operation.
Check SPOUT (5) and SHOWER (4)
connections for leaks.
1
2
3
4
5
6
7
8
9
HANDLE and TRIM
ADJUST HOT LIMIT STOP
3
1
3
2
4
"B""A"
ADJUSTMENT WHEN
WATER IS TOO HOT
PRY OUTWARD TO UNLOCK AND
ROTATE
COUNTER- CLOCKWISE
ONE CLICK.
ADJUSTMENT WHEN
WATER IS TOO COLD
PRY OUTWARD TO UNLOCK
AND ROTATE
CLOCKWISE
ONE CLICK.
By restricting HANDLE rotation and limiting the
amount of hot water allowed to mix with the cold, the
HOT LIMIT SAFETY STOP (1) reduces risk of accidental
scalding. To set the maximum hot water temperature
of your faucet, all you need to do is adjust the setting
on the HOT LIMIT SAFETY STOP (1).
Remove PLUG BUTTON (2). Loosen HANDLE SCREW (3)
and pull off HANDLE (4).
Replace CARTRIDGE CAP (5) and HANDLE (4). Tighten
HANDLE SCREW (3). Replace PLUG BUTTON (2).
Pull off CARTRIDGE CAP (5).
See "A" and "B" for HOT LIMIT STOP (1) adjustment.
5
1
1
1
2
3
5
4
 previous