Filter
Top Products
ADJUST HOT LIMIT STOP
By restricting HANDLE rotation and limiting the amount of hot water allowed to mix with the cold, the HOT LIMIT SAFETY
STOP (1) reduces risk of accidental scalding. To set the maximum hot water temperature of your faucet, all you need to
do is adjust the setting on the HOT LIMIT SAFETY STOP (1).
Turn CARTRIDGE STEM (2) to the OFF position (coldest setting) before making adjustment to
HOT LIMIT STOP (1). Use a flat blade screwdriver to pry free the HOT LIMIT SAFETY STOP (1).
Pull forward and rotate counterclockwise one number to limit hot water temperature. Use
ARROW (3) on CARTRIDGE (4) and NUMBERS (5) on HOT LIMIT STOP (1) for indication.
1
5
1
3
1
1
9
7
5
3
1
1
5
1
3
1
1
9
7
5
3
1
COLDER
(Larger Numbers)
0 1 3 5 7 9 11 13 15
HOTTER
(Smaller Numbers)
0 1 3 5 7 9 11 13 15
1
5
4
3
2
1
5
1
3
1
1
9
7
5
3
1
0
5
4
3
2
1
Install ADAPTER (1) onto VALVE STEM (2) using
SCREW (3).
Align and install HANDLE (4) and tighten with SET SCREW (5)
using 2.5mm Hex Wrench supplied.
Check proper operation of HANDLE (4).
Turn on water supply on and test installed fitting.
Operate valve and diverter spout.
INSTALL HANDLE and TEST FITTING
HEX WRENCH
3
4
)
$
0
''
5
2
1
)
$
0''
INSTALL TRIM
6
9
8
5
5
A
7
3
1
2
4
10
When finished tiling the wall, remove PLASTER GUARD (A)
and turn off water supply.
Push CAP (1) over VALVE CARTRIDGE (2).
Mount ESCUTCHEON (3) and gasket to valve body with SCREWS (4).
Remove PIPE CAP & PLUG (5) from shower pipe and tub filler pipe.
Apply Teflon Tape to both ends of SHOWER ARM (6). Install SHOWER ARM (6)
with FLANGE (8) into shower pipe and tighten.
Thread SHOWER HEAD (7) onto ARM (6) and tighten.
Push SHOWER ARM FLANGE (8) to wall and tighten SET SCREW (9)
with 5/64” hex wrench.
Install SLIP-ON DIVERTER SPOUT (10) onto filler pipe and tighten.
CAUTION: Protect finish on SHOWER ARM,
SHOWER HEAD and TUB SPOUT when installing.
HEX
WRENCH
.