American Standard ASTM E162 Hot Tub User Manual


  Open as PDF
of 2
 
H100
© 2008 AS America Inc.
EVOLUTION™
CORNER WHIRLPOOL
HIGH GLOSS
NOTES:
BATH CAN BE INSTALLED EITHER ABOVE OR BELOW FLOOR LINE AS PIER, ISLAND OR PENINSULA TYPE INSTALLATION.
SUPPORT OF BATH BY INTEGRAL FEET. NO ADDITIONAL SUPPORT REQUIRED. SUPPORT AND ENCLOSING MATERIAL
BY OTHERS.
■ REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH WHIRLPOOL FOR ADDITIONAL INFORMATION.
OPTIONAL 2-WALL TILING BEAD KIT No.TILE-BEAD MUST BE ORDERED SEPARATELY.
▲ CUTOUT TEMPLATE PROVIDED IN SHIPPING BOX. MAY BE REQUESTED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS.
IMPORTANT: Dimensions of xtures are nominal and may vary within the range of tolerances established by ANSI Standard Z124.1
These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided leaet.
8"
(203mm)
19-1/2"(C)
(495mm)
65-3/8"
(1661mm)
18"(A)
(457mm)
21-1/2"(H)
(546mm)
DIMENSIONS OF FIXTURES ARE NOMINAL AND MAY VARY WITHIN THE RANGE
OF TOLERANCES ESTABLISHED BY ANSI STANDARDS Z124.1 AND A112.19.7.
C/L OF
OVERFLOW
7"
(178mm)
76-3/4"
(1949mm)
54-1/2"
(1384mm)
65-3/8"
(1661mm)
3"
(76mm)
7"
(178mm)
15"
(381mm)
5-5/8"
(143mm)
17-3/4"
(451mm)
10"
(254mm)
13-3/4"
(349mm)
CUT OUT
IN FLOOR
FOR DRAIN
OUTLINE OF
CUTOUT
INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
WHIRLPOOL MIN. OPERATING VOL.
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
GENERAL SPECIFICATIONS FOR 6060V WHIRLPOOL
WHIRLPOOL ELECTRICAL SPECIFICATIONS
PUMP
76-3/4 x 65-3/8 x 21-1/2 In. (1949 x 1661 x 546mm)
108 Lbs. (49 Kg.)
824 Lbs. (374 Kg.)
86 Gal. (325 L)
71 Gal. (269 L)
48 x 26-1/2 In. (1219 x 673mm)
63 x 50 In. (1600 x 1270mm)
15 In. (381mm)
24 Lbs./Sq.Ft. (116 Kgs./Sq.m)
2.1 HP, 14.4 AMPS,120V.
E-Z INSTALL WHIRLPOOL HEATER 12.0 AMPS,120V.
Revised 2/08
 previous