American Standard 2425V-LHO.002 Hot Tub User Manual


  Open as PDF
of 2
 
H90
© 2008 AS America Inc.
EVOLUTION™ 5' X 32" IA-LHO / RHO
WHIRLPOOL AND BATHING POOL
HIGH GLOSS
Revised 3/06
NOTES:
BATH CAN BE INSTALLED EITHER ABOVE OR BELOW FLOOR LINE AS PIER, ISLAND, OR PENINSULA TYPE INSTALLATION.
SUPPORT OF BATH BY SUMP BEDDING. SUPPORT AND ENCLOSING MATERIAL BY OTHERS.
■REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH WHIRLPOOL FOR ADDITIONAL INFORMATION.
FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL SUPPORTS.
IMPORTANT: Dimensions of xtures are nominal and may vary within the range of tolerances established by ANSI Standard Z124.1
These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided leaet.
GENERAL SPECIFICATIONS FOR 2425V WHIRLPOOL
WHIRLPOOL ELECTRICAL SPECIFICATIONS
PUMP 1.25 HP, 9.7 AMPS,120V.
60 x 32 x 20-1/2 (1524 x 813 x 521mm)
92 Lbs. (42 Kg.)
675 Lbs. (306 Kg.)
70 Gal. (265 L.)
39 Gal. (148 L.)
42 x 22 In. (1067 x 559mm)
53 x 25-1/2 In. (1346 x 648mm)
17-1/2 (445mm)
51 Lbs./Sq.Ft. (247 Kgs./Sq.m)
INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
WHIRLPOOL MIN. OPERATING VOL.
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
32"
(813mm)
21-1/2"
(546mm)
20-1/2"(H)
(521mm)
19-1/8"(A)
(486mm)
DIMENSIONS OF FIXTURES ARE NOMINAL AND MAY VARY WITHIN THE RANGE
OF TOLERANCES ESTABLISHED BY ANSI STANDARDS Z124.1 AND A112.19.7.
C/L OF
OVERFLOW
CUT OUT IN FLOOR
FOR DRAIN
60"
(1524mm)
32"
(813mm)
7-1/2"
(191mm)
10-1/2"
(267mm)
3"
(76mm)
2-7/8"
(73mm)
6"
(152mm)
13-1/2"
(343mm)
16"
(406mm)
Model 2425V-LHO
shown
GENERAL SPECIFICATIONS FOR 2425V BATHING POOL
60 x 32 x 20-1/2 (1524 x 813 x 521mm)
77 Lbs. (35 Kg.)
661 Lbs. (299 Kg.)
70 Gal. (265 L.)
42 x 22 In. (1067 x 559mm)
53 x 25-1/2 In. (1346 x 648mm)
17-1/2 (445mm)
50 Lbs./Sq.Ft. (242 Kgs./Sq.m)
INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
 previous