5
1)
Options / model variants
NEPTUNE 5 SB FA
2.2 Operating elements
See fold-out page at front of these
operating instructions.
1. Spray lance
2. Cylinder lock
3. Cover for control panel
4. Fuel level gauge
5. Tank fi ller for fuel
6. Receptacle for service crane
and lifting ring
1)
7. Top cover release
8. Service door release
9. High pressure hose
connection
10. Main switch ON/OFF - cold
water/hot water
11. Display (Temperature or
Codes)
12. Temperature control
13. Low fuel indicator
14. Low Nilfi sk-Alto AntiStone
(Anti-Scale) indicator
15. Service interval due/expired
16. Pump oil low
17. Detergent metering knob
18. Pressure gauge
19. Power ON
20. Castor with parking brake
21. Water supply connection
22. Tank fi ller for anti-freeze
23. Tank fi ller for Nilfi sk-Alto
Anti-Scale
24. Canister for detergent B
1)
25. Tank fi ller for detergent A
26. Grip for top cover
27. Cylinder lock
28. Selector switch shampoo/
rinsing
29. Low detergent indicator
30. Coin tester
3 Before starting the cleaner
3.1 Transport and assembly
chine by hand from the pallet.
Due to the weight this work
should be done by at least
three persons.
CAUTION!
Do not hold the plastic tank to lift
the machine as it could become
detached from the frame.
The best places to hold the ma-
chine are
– on the handle
– on the frame between the front
wheels and the guide rollers.
Every fuel-burning appliance, such
as pressure washers, depends
upon a proper mix of fuel and air
(by weight) for proper combustion.
Therefore some adjustment of the
air supply to the burner may be nec-
essary to take account of altitude
and the resulting air pressure. This
is true whether your fuel is ‘Natural
gas’, Propane or Diesel.
Your Nilfi sk-ALTO hot water pres-
sure washer was thoroughly tested
and adjusted for optimum perform-
ance before it left our factory. The
factory
is located at approximately
120m (390 ft) above sea level, and
the combustion settin
gs are optimal
for that elevation.
If your location is higher than
1200m (3900 ft) above sea level,
your burner may require re-ad-
justment for proper performance
and best fuel economy. Contact
your Dealer or Nilfi sk-ALTO for
assistance.
3.2 Set the brake
1. Before using the cleaner for
the fi rst time, check it careful-
ly for any faults or damage.
2. Run the machine only when
it is in perfect working condi-
tion.
3. Set the brake.
4. The slope on which the high
pressure cleaner is placed
must not exceed more than
10
0
in any direction.
1. The safest way to lift the ma-
chine is to use a fork-lift truck
The arrows in the illustration
indicate the best places to po-
sition the fork.
2. It is also possible to lift the ma-