Filter
Top Products
ASSEMBLY
TW84 03/07 Assembly Section 3-8
© 2007 Alamo Group Inc.
ASSEMBLY
FRONT AND REAR DEFLECTORS (Standard Equipment) AND
CHAINGUARDS (OPTIONAL EQUIPMENT AT EXTRA COST)
(Asm-R-0128)
Front and Rear rubber-fabric Deflectors are Standard Equipment and Front and Rear Chain
Guards are optional at extra cost. One type of guards must be installed (and maintained in
good repair) except for agricultural purposes only in areas where persons, vehicles,
livestock, or other property will not be endangered by thrown objects and where such safety
equipment would prevent the mower's reasonable performance of its assigned agricultural task.
DEFLECTORS: Front and Rear Deflectors (Standard Equipment) are recommended for the average user and
will provide protection from thrown objects with proper operation under normal conditions. Deflectors must be
maintained in good repair or replaced after no more than two inches of wear off lower edge.
1. Attach the front Bracket (1) to the front of the mower with 4 - 1/2" x 3" Bolts (5), Locknuts (6), and washers
(7).
2. Attach the front Deflector to the Bracket with Strap (3), 3/8" x 1-1/2" Bolts (6), and Locknuts (4).
Rear Chain Guards (Asm-0041)
1. Attach the Right Guard Mounting Plate (1) & the Left Chain Guard Mounting Plate (2) to the mower with 1/
2" x 1-1/2" Bolts (3), Flatwashers (4) and Locknuts (5). Then attach Deflectors (6) and Bar Strap (7) to
Mounting Plates with 1/2" x 1-1/2" bolts(8) Flatwashers(9) and Locknuts (10). Fasten Side Rear Chain