Filter
Top Products
INTRODUCTION
EAGLE 15 03/09 Introduction Section 2-3
©2009 Alamo Group Inc.
INTRODUCTION
Your medium-duty Cutter is designed primarily for weed, grass, and brush to 3" diameter. With proper
maintenance as described in this manual, your Cutter will provide you with years of dependable service with a
minimum of repairs.
It is recommended that all operators of this implement read this manual or be instructed of its contents as to
safety, proper operation, and maintenance before beginning operation.
Your Cutter has been assembled for operation with a tractor PTO input speed of either 540 or 1000 RPM.
Should you desire to change PTO input speed, contact your local Alamo Industrial dealer who will assist you in
performing the necessary modifications. This machine is recommended for use with tractors rated 50 HP
(37kW) for 540 and 1000 RPM drive.
When ordering parts for the Gearboxes and the Drivelines, be sure to specify the serial number. The serial
number is located outside of the right Tongue attaching Plate on the center Mainframe section.
Chain Guards are extra equipment. Deflectors, Driveline Integral Shields, and Gearbox Shields are standard
equipment and are to be used at all times.
To place the warranty into effect, fill out the warranty card in full, giving all the requested information, and mail
promptly. Be sure to give the serial number of this Cutter.