Filter
Top Products
SAFETY
A60B/A72B 02/07 Safety Section 1-13
©2007 Alamo Group Inc.
SAFETY
Maintenance and Service Safety Instructions and Practices
Make sure the PTO shield, integral driveline shields, and input shields are
is installed when using PTO-driven equipment. Always replace any
shield if it is damaged or missing.
(S3PT-8)
Relieve hydraulic pressure prior to doing any maintenance or repair work
on the Implement. Place the Implement on the ground or securely
blocked up, disengage the PTO, and turn off the tractor engine. Push and pull the Remote
Cylinder lever in and out several times prior to starting any maintenance or
repair work.
(S3PT-9)
Always disconnect the main PTO Driveline from the Tractor before performing service on
the Implement. Never work on the Implement with the tractor PTO driveline connected and
running. Rotating Parts, Blades or Drivelines could turn without warning and cause immediate entanglement,
injury or death.
(S3PT-11)
N
ever
i
n
t
er
f
ere w
ith
f
ac
t
ory-se
t
h
y
d
rau
li
c ca
lib
ra
ti
ons.
A
ny c
h
ange
i
n ca
lib
ra
ti
on cou
ld
cause a failure of the equipment and may result in injury. (SBH-13)
Always maintain the safety signs in good readable condition. If the safety signs are
missing, damaged, or unreadable, obtain and install replacement safety signs immediately.
(SG-5)
D
o no
t
mo
dif
y or a
lt
er
thi
s
I
mp
l
emen
t
.
D
o no
t
perm
it
anyone
t
o mo
dif
y or a
lt
er
thi
s
Implement, any of its components or any Implement function.
(SG-8)
N
ever wor
k
un
d
er
th
e
I
mp
l
emen
t
,
th
e
f
ramewor
k
, or any
lift
e
d
component unless the Implement is securely supported or blocked up
to prevent sudden or inadvertent falling which could cause serious
injury or even death.
(SG-14)
Never attempt to lubricate, adjust, or remove material from the Implement while it is in
motion or while tractor engine is running. Make sure the tractor engine is off, the
transmission in park, the parking brake set, and that the key is with you before working on
the im
p
lement. (SG-20)