Filter
Top Products
www.airkinglimited.com
111597005 Rev.A 10-07
3 of 12
4. Plug both the 3 wire and 4 wire quick connect cords from the
blower into the appropriate receptacles located on the inside
front of the hood canopy. These cords will only fit into the
receptacles one way (Figure 3).
5. Reinstall the rear bottom plate by fitting the back edge of the
plate into the channel located on the back of the hood and
reinstalling the two screws and washers removed in
Step 1
(Figure 5).
SECTION 4
Finishing the Installation
1. Install the included fuse into the electrical panel by turning
the fuse cap counter clockwise and pulling out. Insert the
included 1/4" x 1-1/4" time delay fuse in the holder and reinstall
into the panel (Figure 6).
NOTE: If you need to replace the fuse, replace with a 1/4" x 1-1/4"
Bussman MDA-3 or equivalent 3 amp, 250V ceramic, time delay
fuse only.
2. Refer to the hood instruction manual to complete the
installation, for maintenance, and before restoring power.
3. The blower is covered under the range hood’s warranty.
Fuse
Figure 6
Cap
Channel
Figure 5
Screw
Bottom Plate
Washer