Agri-Fab 552493 Chipper User Manual


  Open as PDF
of 28
 
11
25. Assemble a short tarp strap to rear door using one
1/4"x1-1/4"hexbolt,two1/4"atwashersandone
1/4" nylock nut. Assemble an "S" hook through loose
endofstrap.Seegure15.Repeatonothersideof
door.
26. Assemble door to rear of cart by resting bottom of
door on door supports and pushing top of door in
against cross brace. Secure top of door using door
latchesoneachside.Seegure15.
27. Hook both the tarp straps onto the 1/4" x 1" hex bolts
inthesidesofthecart.Seegure15.
28. Attach the engine/impeller housing assembly to the
upper holes in the angles welded to the tongue. Use
four 5/16" x 3/4" hex bolts and 5/16" nylock nuts.
Tighten.Seegure16.
FIGURE 16
FIGURE 15
5/16"
NYLOCK
NUT
5/16" x 3/4"
HEX BOLT
WELDED
ANGLES
FRONT
TONGUE
FIGURE 17
29. Assemble the elbow to the impeller housing using
four 5/16" x 3/4" self tapping hex bolts and four nylon
washers. Push while turning to help start the bolts into
the unthreaded holes. Tighten.Seegure17.
30. To center the elbow with the opening in the hard top:
a. Push the vinyl boot back inside the opening.
b. Loosen by approximately 1/4 turn each, the four
boltsthatyouassembledingure16.
c. Push against the elbow to center it with the sides
of the opening.
d.Retighten the four bolts that you loosened.
31. Pull the vinyl boot onto the end of the elbow.
Center elbow between
sides of opening
Loosen (4) bolts
1/4 turn each
5/16" x 3/4"
HEX BOLT
(Thread Forming)
NYLON
WASHER
1/4" x 1-1/4" HEX BOLT
1/4" FLAT WASHER
1/4" NYLOCK NUT
TARP STRAP (SHORT)
DOOR
SUPPORTS
DOOR LATCH
1/4" FLAT
WASHER
"S" HOOK
1/4" x 1"
HEX BOLT
 previous next