6
ATTACHING DETHATCHER TO TRACTOR
19
FRONT
3
12
SELF THREADING BOLT
SELF THREADING BOLT
FRONT MOUNTING HOLES
• If the front of your tractor has front mounting holes as
shown in gure 7, continue on to gure 8.
• If the front of your tractor DOES NOT have front
mounting holes, go to gure 10.
• Remove two self threading bolts (if present) from
front cross-member of tractor. Assemble bolts through
lower slots in hitch bracket, then reinstall them back
into front crossmember. (Make sure notches at top of
hitch bracket and crossmember are aligned.)
• From behind tractor's front crossmember, insert two
3/8" x 1" hex bolts (3) through holes in crossmember
and through upper slots in hitch bracket. Secure with
two 3/8" nylock hex nuts (12).
• Go to gure 11 on page 7.
FIGURES 9 AND 10 ARE ONLY FOR TRACTORS WITHOUT FRONT MOUNTING HOLES. FOR
ALL OTHER TRACTORS CONTINUE TO FIGURE 11.
19
27
3
12
7
8
9
x 1
27
x 1
19
x 4
3
x 4
12