Agri-Fab 45-0410 Spreader User Manual


  Open as PDF
of 8
 
5
HOW TO USE YOUR SPREADER
ADJUSTING THE FLOW RATE SETTING
1. Loosen the wing nut that fastens the control to the
handle.
2. Slide the Adjustable stop to the desired setting and
retightenthewingnut.Seegure5.
OPERATION
APPLICATION TIPS
1. This unit will cover a 4 to 8 foot wide area depending
on the material used and the towing speed.
2. To avoid misses or striping, make each pass about 5 feet
from the previous one so some overlapping of spread
pattern does occur.
3. For easiest application, spread across the shortest
edgesoflawnrst,makingtwo"header"stripsfora
turning area, and then spreading between the header
strips.Seegure6.
4. If lawn is odd shaped, spread a border around the edges
andthenspreadbetweentheborder.Seegure6.
5. Keep wheel approximately 4 feet from any area you do
not wish to spread.
IMPORTANT: Be careful when using spreader around
ornamental plants because weed control chemicals can
damage these plants.
USING YOUR SPREADER
1. Check the material package and the Spreader Settings
sheet included with your spreader for the proper spreader
setting and application rate.
2. Beforellingspreader,movethecontrollevertothe
"OFF" position.
3. Movespreaderontoaatsurface-eitherawalkora
driveway-andll.
4. Slide the Adjustable Stop to the desired setting.
5. Start the spreader in motion, then move the control
lever forward against the adjustable stop to begin
spreading.
6. Maximum towing speed - 3 M.P.H.
NOTE: Always place control lever in the "OFF" position while
llingspreaderandwhenstoppingorturning,toprevent
release of excess fertilizer.
FIGURE 6
FIGURE 5
CHECK FOR LOOSE FASTENERS
1. Make a thorough visual check of the Spreader for any
bolts and nuts which may have loosened. Retighten any
loose bolts and nuts.
LUBRICATION
1. Apply a few drops of oil to all moving parts.
CLEANING
1. Always empty spreader after each use, storing leftover
material in it's original bag.
2. Wash the spreader and dry thoroughly after each
use.
STORAGE
1. Empty and clean the hopper as instructed in maintenance
section.
2. Store in a clean, dry area.
MAINTENANCE & STORAGE
FLOW CONTROL LEVER
ADJUSTABLE STOP
 previous next