Agri-Fab 45-0361 Lawn Mower User Manual


 
8
ASSEMBLY
INSTALL TOWBAR TUBE TO REAR
QUADRANT
Remove Hex Bolts and lift Front Drive Cover from
mower housing.
Rest end of Tow Bar Tube on front edge of mower.
Feed Wire Harness in end of Tow Bar Tube through
large hole in back wall of Rear Quadrant.
Place Towbar Tube into Rear Quadrant, align holes
and insert 3/8 x 2-3/4 Hex Bolt through quadrant
and rear hole of Tube.
Secure tightly with 3/8 Hex Lock Nut and then
loosen 1/4 turn to allow Tube to pivot freely inside
Rear Quadrant.
Assemble a 3/8 Flat Washer onto a 3/8 x 2-3/4 Hex
Bolt.
Insert Bolt and Washer into slot in Rear Quadrant
and into hole in Towbar Tube.
Secure Tightly with 3/8 Flat Washer and 3/8 Hex
Lock Nut, then loosen 1/4 turn to allow Tube to
pivot freely inside Rear Quadrant.
NOTE: Towbar Tube must pivot freely inside Rear
Quadrant when Latch is pulled from notch.
INSTALL WIRE HARNESS TO ENGINE
Feed Wire Harness up through hole in middle of Front
Drive Cover.
Install one Wire to Engine Magneto Ground Terminal.
(The same Terminal as red Wire from inside Mower.)
Install other Wire of Wire Harness to Engine Ground
Base. (The same Terminal as black Wire from inside
Mower.)
Refasten Front Drive Cover to mower housing.
INSTALL CLUTCH TO TOWBAR TUBE
Place Clutch Cable forward along Towbar Tube.
Spread ends of three Cable Clips and place around
Clutch Cable.
Place Clutch Cable on top of Towbar Tube and align
Cable Clips with bolt holes in Towbar Tube.
Secure with three #10 Screws.