Filter
Top Products
5
4. Arrange the mast lift straps as shown in figure 4.
Place the straps and the spacer between the mast
sides, fastening them to the lower hole in the mast
sides using a 1/2" x 3-1/2" hex bolt and 1/2" Nylock
hex nut. Do not tighten yet.
FIGURE 4
MAST LIFT
STRAP
SPACER
1/2" NYLOCK
HEX NUT
1/2" x 3-1/2"
HEX BOLT
FIGURE 6
1/2" x 1-1/2"
HEX BOLT
1/2" NYLOCK
HEX NUT
SUPPORT
BRACKET
MAST LIFT
STRAP
FIGURE 5
PIVOT PIN
1/8" HAIR
COTTER PIN
5. Install the pivot pin through the upper hole at the
end of the mast sides. Secure the pivot pin with a
1/8" hair cotter pin. See figure 5.
6. Attach the lower end of each mast lift strap to the
outside of the welded frame braces and attach the
support bracket to the inside of the frame braces.
Use two 1/2" x 1-1/2" hex bolts and two 1/2"
Nylock hex nuts. Do not tighten yet. See figure 6.
7. Attach the front of the weight bracket to the sup-
port bracket using two 3/8" x 1" hex bolts and two
3/8" Nylock hex nuts. Attach the sides of the
weight bracket to the rear of the frame using two
3/8" x 2-1/4" hex bolts and two 3/8" Nylock hex
nuts. See figure 7.
8. Tighten all loose bolts and nuts at this time.
FRAME
BRACES
MAST
SIDE
FIGURE 7
3/8" x 1"
HEX BOLT
3/8" x 2-1/4"
HEX BOLT
WEIGHT
BRACKET
3/8" NYLOCK
HEX NUT
3/8" NYLOCK
HEX NUT