Agri-Fab 45-03152 Spreader User Manual


  Open as PDF
of 12
 
4
TOOLS REQUIRED FOR ASSEMBLY
(2) 7/16" Wrenches
1. Assemble vinyl caps onto the ends of the R.H. and L.H.
HitchTubes.Seegure1.
2. Assemble the R.H. Hitch Tube to the spreader frame
tube using two 1/4" x 2" hex bolts and 1/4" nuts. Do not
tighten yet.RepeatforL.H.HitchTube.Seegure1.
FIGURE 1
3. Assemble the Hitch Control Tube between the Hitch
Tubes using two 1/4" x 1-3/4" hex bolts and 1/4" nuts.
Tighten allboltsandnuts.Seegure2.
FIGURE 2
4. Assemble the Hitch Brackets to the Hitch Control Tube
using two 1/4" x 1-3/4" hex bolts and 1/4" nuts. Tighten.
Seegure3.
5. Assemble the hitch pin through the hitch brackets and
securewiththe1/8"haircotterpin.Seegure3.
6. Assemble the vinyl cap onto the Hitch Control Tube. See
gure4.
7. Assemble the Control Cable to the Hitch Control Tube
usingthecarriageboltandnylonwingnut.Seegure
4.
FIGURE 4
FIGURE 3
ASSEMBLY INSTRUCTIONS
1/4" x 2"
HEX BOLT
1/4" NUT
VINYL CAP
1/4" NUT
1/4" x 1-3/4"
HEX BOLT
1/4" NUT
1/4" x 1-3/4"
HEX BOLT
HAIR COTTER PIN
HITCH PIN
REMOVAL OF PARTS FROM CARTON
Remove all parts and hardware packages from the carton.
Lay out all parts and hardware and identify using the
illustrations on page 3.
CARRIAGE BOLT
NYLON
WING NUT
VINYL CAP
 previous next