Filter
Top Products
4
TO REMOvE UNiT FROM
CARTON
• Cut from top to bottom all four corners of the carton
and lay panels at. (See Fig. 1)
• Remove the lag screw that holds the oating hitch to
the packing skid.
• Disassemble and discard carton's wood top and side
supports.
• Remove four hex bolt, hex nuts and at washer from
the hold down brackets at the rear of the carton.
• Remove and save the two Flat Washers and Cotter
Pins from the rear axle. Reuse when attaching gauge
wheels.
• Discard all other packing hardware and hold down
brackets.
ASSEMBLY
TO iNSTALL ThE TiLLER
GAUGE WhEELS
• Assemble Gauge Wheels onto the Rear Axle with the
extended end of Hub facing inward. Secure with the
Flat Washers and Cotter Pins which you removed from
the axle during unpacking. (See g. 2.)
• Right hand (RH) and left hand (LH) are determined
from the drivers position while seated on the tractor.
• We recommend that you remove the Mower Deck
before using the Tiller. Refer to your Tractor Owner's
Manual.
3/8" NYLOCK
NUT
TO iNSTALL ThE TiLLER TiNE
ASSEMBLiES
• Attach the oating hitch to the tractor's draw bar.
(Refer to Operating Instructions on page 7.)
• Remove the preassembled 3/8" x 2" hex bolt and 3/8"
nylock nut from the L.H. Tine Assembly. Slide the tine
assembly onto the Transmission Axle on the left side
of the tiller and secure with the hex bolt and nylock nut.
(See g. 3.) Repeat for the R.H. side.
FiG. 1
FiG. 2
FiG. 3