Agri-Fab 45-0299 Lawn Aerator User Manual


  Open as PDF
of 12
 
5
6. Assemblea2.38"longspacer,a3/4"atwasher,the
middlebrace,a3/4"atwasheranda3.90"longspacer
onto the long end of the shaft. The bent lip of the middle
brace must face the short end of the shaft. Next assemble
a double spool assembly, a 5.29" long spacer, another
double spool assembly, a 1.00" long spacer and a 3/4"
atwasherontotheshaft.Seegure4.
FIGURE 5
FIGURE 6
8. Assemble a wheel to a wheel bracket using a 1/2" x 3-
1/2" hex bolt, a 1/2" jam nut and a1/2" nylock jam nut.
Adjust the nuts so that the wheel is held securely but
willspinfreely.Repeatonotherside.Seegure6.
FIGURE 7
9. Assemble the hitch bracket to the tongue using two 3/8"
x 1" hex bolts and 3/8" nylock nuts. Tighten.Seegure
7.
10. Assemble the hitch pin through the hitch bracket and
thetongue.Secureitwiththehaircotterpin.Seegure
7.
7. Rotate the wheel bracket fastened to the middle of the
shaft so that it is pointing upward. Assemble an end
plate,a3/4"atwasherandasecondwheelbracket
onto the long end of the shaft. Point this wheel bracket
asshowningure5.Secureittotheshaftusinga1/4"
x 1-3/4" hex bolt and 1/4" nylock nut. Tighten. Repeat
on short end of shaft.
FIGURE 4
2.38" LONG
SPACER
1.00" LONG
SPACER
3/4" FLAT
WASHER
MIDDLE
BRACE
3.90" LONG
SPACER
3/4" FLAT
WASHER
LONG END
OF SHAFT
5.29" LONG
SPACER
3/8" NYLOCK NUT
3/8" x 1"
HEX BOLT
HAIR COTTER PIN
HITCH
PIN
1/4" x 1-3/4"
HEX BOLT
1/4" NYLOCK NUT
3/4" FLAT
WASHER
MIDDLE WHEEL BRACKET
POINTING UP
1/2" NYLOCK JAM NUT
1/2" x 3-1/2"
HEX BOLT
1/2"JAM NUT
 previous next