Filter
Top Products
5
9. Assemble the boom mount bracket to the rear of the
hitch tubes using two 5/16" x 2" hex bolts and 5/16"
hex nuts. See figure 5.
10. Assemble the boom bars to the boom mount bracket
using two 5/16" x 1-1/4" carriage bolts, tooth lock
washers (between the bar and bracket), 5/16" flat
washers and knobs. The boom connecting hose
should extend upward. See figure 6.
NOTE: Make sure the nozzle openings face straight
down when the boom bars are in the horizontal
operating position.
FIGURE 7 VIEWED FROM REAR
FIGURE 6
FIGURE 5
11. Assemble the large and small spray gun clips to the
side of the tank using two #10 x 1/2" screws and #10
lock washers. See figure 7.
5/16" HEX NUT
BOOM MOUNT
BRACKET
5/16" x 2"
HEX BOLT
SPRAY GUN
CLIP (LARGE)
SPRAY GUN
CLIP (SMALL)
#10 x 1/2"
SCREW
#10 LOCK
WASHER
CARRIAGE BOLT
5/16" x 1-1/4"
KNOB
5/16" WASHER
WASHER
(TOOTH LOCK)
BOOM BAR
BOOM CONNECTING HOSE
7. At this time tighten all bolts starting with the bolts in
figure 2, then the bolts in figure 3.
8. Install the drain in the rear of the tank as shown in
figure 4. Place a 3/4" garden hose gasket onto the
drain body and insert the drain body out through the
hole in rear of the tank. Outside the tank, assemble
the nylon washer, then the nylon nut onto the drain
body. Tighten the nut securely enough to prevent
leaking, being careful not to damage the plastic
parts. Place the O-ring inside the nylon cap and
screw the cap onto the end of the drain body. See
figure 4.
FIGURE 4
NYLON CAP
DRAIN BODY
HOSE
GASKET
NYLON
WASHER
NYLON NUT
O-RING