Filter
Top Products
5
FIGURE 7
13. Assemble the leg stand tube to the handle tube (long)
using two 1/4" x 1-1/2" hex bolts. Secure tightly with
two 1/4" nylock nuts. See gure 6.
14. Place a vinyl cap over the end of the leg stand tube.
See gure 6.
FIGURE 5
FIGURE 6
15. Assemble the ow control link (end with small hole)
to the ow control arm using a 1/4" x 1" hex bolt, a
nylon washer and a 1/4" nylock nut as shown in gure
7. Tighten carefully. The ow control link should not
be loose but should pivot with no more than slight
resistance.
HANDLE TUBE (LONG)
1/4" x 1-1/2"
HEX BOLTS
1/4"
NYLOCK
NUTS
VINYL CAP
LEG STAND TUBE
IMPORTANT: Do Not asssemble handle tube to same
side of crossover tube as shaft support plate.
9. Place the long handle tube onto the crossover tube
on the side opposite from the shaft support plate.
Fasten with the bolt, washer and nut removed in the
previous step. See gures 4 and 5. Do not tighten
at this time.
10. Assemble two handle braces to the inside of the hopper
frame, one on each side, using two 1/4" x 1-1/2" hex
bolts and two 1/4" nylock nuts. See gure 5. Do not
tighten at this time.
11. Assemble the other end of the two handle braces to
the long handle tube using a 1/4" x 1-1/2" hex bolt and
1/4" nylock nut. Do not tighten at this time.See gure
5.
12. Tighten all nuts and bolts in same sequence as
assembled in steps 9 through 11. See gure 5.
MIDDLE
BOLT
MIDDLE
NUT
HANDLE TUBE (LONG)
HEX BOLT
1/4" x 1-1/2"
HEX BOLT
1/4" x 1-1/2"
HITCH
BRACE
1/4"
NYLOCK
NUT
CROSSOVER
TUBE
SHAFT
SUPPORT
PLATE
FLOW CONTROL
LINK
FLOW
CONTROL
ARM
1/4"
NYLOCK
NUT
1/4" x 1"
HEX BOLT
SMALLEST
HOLE
NYLON
WASHER