Filter
Top Products
5
9. Assemble a spacer and a 1-5/8" flat washer onto the
end of the axle that has the large hole. See figure 4.
10. Place the drive wheel onto the axle (air valve to outside)
and secure with a 1/4" x 1-3/4" hex bolt and a 1/4" hex
lock nut. See figure 4.
FIGURE 4
11. Turn the spreader upright on its wheels.
12. Assemble the hitch bracket to the top of the hitch tube
using two 3/8" x 1-1/4" hex bolts, 3/8" lock washers and
3/8" hex lock nuts. See figure 5.
13. Assemble the hitch pin through the hitch bracket and
the hitch tube and secure with the hair cotter pin. See
figure 5.
FIGURE 5
14. Assemble the flow control link (end with small hole) to
the flow control arm using a 1/4" x 3/4" hex bolt, a nylon
washer and a 1/4" hex lock nut as shown in figure 6.
Tighten carefully. The flow control link should not be
loose but should pivot with no more than slight resis-
tance.
FIGURE 6
1/4" HEX
LOCK NUT
1/4" x 1-3/4"
HEX BOLT
DRIVE WHEEL
AIR VALVE
SPACER
1-5/8" DIA.
FLAT WASHER
3/8" x 1-1/4"
HEX BOLT
3/8" LOCK
WASHER
3/8" HEX
LOCK NUT
HITCH PIN
HAIR COTTER PIN
FLOW CONTROL
LINK
FLOW
CONTROL
ARM
1/4" HEX
LOCK NUT
1/4" x 3/4"
HEX BOLT
SMALLEST
HOLE
NYLON
WASHER