Agri-Fab 175 Spreader User Manual


  Open as PDF
of 12
 
9
CHECK FOR LOOSE FASTENERS
1. Beforeeachusemakeathoroughvisualcheckofthe
spreaderforanyboltsandnutswhichmayhaveloosened.
Retightenanylooseboltsandnuts.
CHECK FOR WORN OF DAMAGED PARTS
2. Checkfor wornor damagedparts beforeeachuse.
Repairorreplacepartsifnecessary.
CHECK TIRE INFLATION
3. Checkiftiresareadequatelyinatedbeforeeachuse.Do
notinatebeyondmaximumrecommendedpressure.
FIGURE 15
1. Rinseinsideofhopperandexteriorofspreaderanddry
offbeforestoring.
2. Storeinaclean,dryarea.
CLEANING
4. Rinseinsideofhopperandexteriorofspreaderanddry
offbeforestoring.
LUBRICATE (Seegure15.)
5. Lightly apply automotive grease as needed to the
sprocketandgear.
6. Oilthenylonbushingsontheverticalsprocketshaft
andontheaxleatleastonceayear,ormoreoftenas
needed.
7. Oilrighthand(idler)wheelbearingatleastonceayear
ormoreoftenasneeded.
MAINTENANCE
GREASE
OIL
OIL
STORAGE
CAUTION: DO NOT inatetiresbeyondthe
maximumrecommendedpressureprinted
onsideoftire.
REPLACING SLOTTED GEAR
1. If the axle, slotted gear and sprocket assembly is
disassembled,markdownthepositionsofthepartsas
theyareremoved.Thedrivewheelandsprocketpositions
inrelationtotheslottedgeardeterminewhichdirection
thespreaderplatewillspin.Besuretoreassemblethem
intheiroriginalpositions.(Refertogure4onpage5.)
Useshimwashers(Ref.no.21onpages10and11)
asneededforminimumbacklash.Addgreasetogear
andsprocket.
SERVICE AND ADJUSTMENTS
SHAFT SUPPORT PLATE
SLOTTED GEAR
IF THE SPREADER LOCKS UP
1. Turnthespreaderoversothatthewheelsareoffthe
ground.
2. Loosenallthreenutsontheshaftsupportplatejust
enoughsothattheboltscanbeturnedeasilywitha
wrenchbutcannotbeturnedbyhand.
3. Spinthedrivewheelandnotehowfreelyitspinsand
howmuchnoisetheslottedgearmakes.
4. Tofreeupthewheelandgear,tapgentlyonthefront
orrearedgeoftheshaftsupportplatetomoveit
slightlyforwardorbackward.Youcanalsotapatthe
cornersoftheplatetoangleitslightly.
5. Spinthedrivewheelaftereachadjustmenttoseeifit
spinsmorefreelyandifthegearnoiseisreduced.
6. Continuemakingslightadjustmentsuntilyoundthe
positionwherethedrivewheelspinsmostfreelyand
thegearmakestheleastnoise.
7. Secure the shaft support plate in this position by
retighteningallthreenutsthatyouloosened.
FIGURE 16
 previous next