Filter
Top Products
Setting Up a Data Pattern
8
You can now set the channel mode, timing and
level parameters for the channel
Switch to the Channel Page
Select Pulse Mode Data
Select Pulse Type NRZ
Select the ECL level format
Indicates that the Parameters
are set for Channel 1
You can switch
between the two channels
by pressing this softkey
1
2
3
4
The LEDs show the status
of the outputs
gray = disabled, green = enabled,
crossed out = all outputs disconnected
Enable the Channel 1 normal Output
by pressing the respective softkey
5
5
Now let’s set the data
Switch to the Data Page
Switch to the Numeric Edit Mode
Enter a data pattern
length of 32 bits
Enter your data pattern
1
4
2
3
-
-