Filter
Top Products
Basic Reminders About Your AeroGarden
(continued)
Raise Lamp Hood (Lights)
As plants grow to 1-2” from lights, raise Lamp Arm one Locking Button at a time. Be sure Lamp Arm is set on the
lowest Locking Button when starting your AeroGarden PRO
100
.
Unplug AeroGarden PRO
100
and remove Bowl from Base.
1
Raise Lamp Arm/Lamp Hood
by holding Lamp Arm & Hood
with one hand, and pushing in
Locking Button with the other.
2
Replace Bowl on Base and
plug in AeroGarden PRO
100
.
3
When “Replace Grow Bulbs” light on Control Panel begins blinking
after 6 months of use…
• Unplug AeroGarden PRO
100
.
• Remove old Grow Bulbs and carefully discard*.
IMPORTANT: To avoid burning, be sure Grow Bulbs are cool before handling.
• Insert new Grow Bulbs into Lamp Hood.
• Plug in AeroGarden PRO
100
and press and release “Reset” button to
restart grow bulb timer.
Early Grow Bulb Replacement
If you replace Grow Bulbs before “Replace Grow Bulbs” light illuminates, be
sure to restart grow bulb timer as follows:
• Press and hold “Lights” button until white light next to your selected plant
type starts blinking – about 5 seconds.
• Release “Lights” button. The plant type selected light will continue to blink
for about 9 seconds. While plant light is still blinking…
• Quickly press and release “Reset” button. “Replace Grow Bulbs” light will
blink once and the plant selected light will stop blinking.
Replace Grow Bulbs – Order bulbs at www.aerogardensupport.com
12
Push Locking
Button in
*Check with local recycling authorities for
light bulb recycling availability in your area.