Filter
Top Products
Water LowAdd Nutrients
Replace
Bulbs
Salad
Greens
Flowers
Vegetables Live Plants
Herbs
• Water Low
When light blinks add
water up to “Fill To Here.”
• Add Nutrients
(Feed Garden - Basic Feeding)
When “Add Nutrients” and “Water
Low” lights start blinking (every 2
weeks), add 2 nutrient tablets* and
fill the Bowl with water up to “Fill
to Here.” Press and release “Reset”
button to restart nutrient timer and
turn off blinking lights.
*See Tending & Harvesting Guide for
plant-specific nutrient information.
• Replace Bulbs
†
When light blinks (after 6 months
of use), it is time to replace Grow
Bulbs. Bulbs can be ordered at
www.aerogardensupport.com or
from your retailer. After replacing
Grow Bulbs, press “Reset” button
to restart grow bulb timer and turn
off flashing light.
NOTE: If you store your AeroGarden 6
between uses, grow bulb timer
automatically stops when Garden
is unplugged.
†
See complete replacement instructions
on next page.
• Lights On/Off
Use to occasionally override built-in light timer. Once pushed,
lights will stay off/on until the next time built-in light timer is set
to go on/off. This will not affect the timing of your light cycle,
and occasional use of this feature will not harm your plants.
AeroGarden
6
Control Panel
Basic Reminders About Your AeroGarden
• Remove Bio-Domes
When plants appear through hole in
Seed Pod Label, remove Bio-Dome
and discard or recycle.
NOTE: Never remove Seed Pod Labels.
11
• Select
The number of hours lights are
on and off depends on which
plant type is selected.