Filter
Top Products
AeroGarden
3
Control Panel
Replace
Bulb
Add
Nutrient
FILL TO
HERE
Basic Reminders About Your AeroGarden
REPLACE BULB*
When light illuminates (after 6 months of use),
it is time to replace Grow Bulb. Order bulbs at
www.aerogardensupport.com or from your retailer.
After replacing Grow Bulb, press and hold “Reset”
button until “Replace Bulb” light blinks (3 seconds).
Release “Reset” button, then press and release again.
“Replace Bulb” light will go off and timer is now reset.
*See complete replacement instructions on page 11.
ADD NUTRIENT (Feed Garden - Basic Feeding)
When “Add Nutrient” light illuminates (every 2
weeks), add 1 nutrient tablet and fill Bowl with
water up to “Fill To Here.”
Press and hold “Reset” button until “Add Nutrient”
light blinks (3 seconds). Release “Reset” button,
then press and release again. “Add Nutrient” light
will go off and timer is now reset.
LIGHT On/Off
Use to occasionally override built-in light timer. Once pushed, light
will stay off/on until the next time built-in light timer is set to go
on/off. This will not affect the timing of your light cycle, and oc-
casional use of this feature will not harm your plants.
REMOVE
BIO-DOMES
When plants appear
through hole in
Seed Pod
Label, remove
Bio-Dome
and discard or recycle.
Note: Never remove Seed Pod Labels.
WATER
LEVEL LOW
When water
level indicator is
RED, add water
to “Fill To Here.”
“Fill To Here”
RESET
Use to reset “Add Nutrient”
and “Replace Bulb” timers
when each light illuminates.
9