Filter
Top Products
-
5
--
4
-
4 • OPERATION
After the main unit and the wireless sensor are both powered on and wirelessly
synchronized, no further input is required. If you have problems receiving the
outdoor temperature, please refer to the troubleshooting section of this manual.
Forecast Icon
This feature gives you the predicted weather
forecast for the next 12 to 24 hours based on an
advanced algorithm that includes barometric
pressure and temperature. This weather station will
provide the most accurate forecast that a single
station weather instrument can provide.
B
Minimum/Maximum Recorded Temperatures
T
he main unit has a memory function for storing minimum and maximum recorded indoor and
o
utdoor temperatures. You may view the MIN and MAX recorded temperatures by pressing the
“
MIN/MAX” button on the back of the main unit.
C
Trend Indicator Icons
T
he main unit features arrow icons for indicating a falling, steady or rising temperature. This
f
eature is shown for the outdoor and indoor temperatures.
D
C
C
D
D
B
14 Day Learning Mode
This weather station has a patent pending fourteen
day learning mode calibration process. During this
learning mode, the weather station will make
altitude calculations that may aect the accuracy of
the forecast icon. After the initial 14 day learning
period, the forecast feature will be ready for superior
operation.
A
Re-Synchronize Wireless Signal
This weather station features a button for
re-synchronizing the wireless signal with the
outdoor temperature sensor. Press this button to
attempt to re-synchronize in the event you lose
connection with the outdoor sensor due to
interference or battery changes.
E
ºC/ºF Selection
Press this button to switch between ºC or ºF
temperature scale selections.
F
A
RE-SYNCºC/ºF
MIN
MAX
E
C
F
Problem
Bad Temperature
Reception
Relocate the main unit and/or the wireless
sensor. Both units must be within 100 feet
from each other. Make sure both units are
placed at least 3 feet from other electronic
appliances and devices that may interfere
with the wireless communication (such as
TV’s, microwaves, computers etc).
You may need to press the “RE-SYNC”
button on the back of the main unit.
NOTE: It may take up to 20 minutes for the
main unit to re-synchronize with the sensor
when batteries are replaced.
Main Unit
Display Not Working
Make certain that the batteries are installed
correctly. The batteries may need replacing.
If none of the above solutions resolve the
problem, you may need to reset both units
by removing and re-installing the batteries
in both unit.
Possible Solutions
Product Registration
To receive product information, register
your product online. It’s quick and easy!
Log on to http://www.chaneyinstrument.com/product_reg.htm
FLASHING TEMPERATURE
Extended periods of cold temperatures ( below -4ºF / -20ºC ) can cause
alkaline batteries to function improperly. This will cause the outdoor
wireless sensor to stop transmitting temperature readings. Use lithium
batteries in these low temperature conditions to ensure continued
operation for wireless sensors placed outdoors.
40
5 • TROUBLESHOOTING
This product features a low power wireless signal, so it does not interfere with
other wireless devices in your location. Occasionally, there will be a temporary
disconnection to the wireless sensor. In most cases, the temperature will show
again if the main unit and wireless temperature sensor are able to re-connect
automatically. If the disconnection lasts longer than a few hours, refer to this
troubleshooting guide.