1. Manuals
  2. Lawn and Garden Support
  3. Yard Machines Support
  4. Lawn Mower Support
Support User Manuals
Question About Yard Machines Lawn Mower 13AS690G502
how to put drive belt on to transmission...

how to put drive belt on to transmission

Asked by orlan on 07/27/2013 2  Answers

ManualsOnline posted an answer 11 years, 3 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

Rewarder User posted an answer 11 years ago

5 1 Remove the screws for the rear deflector, the rubber guard between the rear tires. Turn the lawnmower on its side with the air filter facing the ground. The guard can now be pulled off the lawnmower. 2 Unscrew the bolts that hold the rear baffle, the back section of the lawnmower deck, with the wrench. Remove the shield behind the baffle and the drive belt will now be visible. It is wrapped around two pulleys and can be pulled out with ease. Sponsored Links Visio Network Diagrams Easily discover and map networks with a free trial of WhatsupGold. WhatsupGold.com/Diagram 3 Slide a new belt around the two pulleys. Make sure it is tight around the pulley's connector plate. 4 Snap the shield back into position. Place the baffle over the shield and bolt it back to the lawnmower. 5 Slide the rubber guard over the back of the lawnmower. Set the mower deck back onthe ground. 6 Screw the screws holding the guard into position. Sponsored Links Read more: http://www.ehow.com/how_6500860_install-lawnmower-drive-belt.html#ixzz2aUNRw06l
Was this answer helpful?

ManualsOnline posted an answer 11 years, 3 months ago

0 1 Remove the screws for the rear deflector, the rubber guard between the rear tires. Turn the lawnmower on its side with the air filter facing the ground. The guard can now be pulled off the lawnmower. 2 Unscrew the bolts that hold the rear baffle, the back section of the lawnmower deck, with the wrench. Remove the shield behind the baffle and the drive belt will now be visible. It is wrapped around two pulleys and can be pulled out with ease. 3 Slide a new belt around the two pulleys. Make sure it is tight around the pulley's connector plate. 4 Snap the shield back into position. Place the baffle over the shield and bolt it back to the lawnmower. 5 Slide the rubber guard over the back of the lawnmower. Set the mower deck back onthe ground. 6 Screw the screws holding the guard into position.
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual