1. Manuals
  2. Lawn and Garden Support
  3. Troy-Bilt Support
  4. Trimmer Support
Support User Manuals
Question About Troy-Bilt Trimmer TB25CS
Pull cord repair...

How do I remove the cover to get to the pull string on my Troy-bilt trimmer

Asked by Jim Dooley on 07/28/2008 3  Answers

ManualsOnline posted an answer 16 years, 2 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

James posted an answer 16 years, 2 months ago

5 Remove the control handle by removing the torx screws (6), disconnect the throttle cable and the wires to the kill switch, pull the wires and the throttle cable out of the handle half. Remove the 3 torx screws from the plastic retainer holding the drive (boom) to the front of the clutch drive. The clutch drive has an allen screw in the inside of the drive hub socket, right hand thread. Stick a small screwdriver through the plastic housing into the flywheel cooling fins and loosen the hub screw. The expaning clutch shoe assembly is unscrewed ( right hand thread) from the shaft. I used a chisel and hammer to break it loose. Don't lose the washer under the clutch hub and the big washer under the expanding show assembly! Then remove the 4 torx machine screws and 1 coarse thread screw from the plastic housing and remove. Remove the speed nut (pry up with a screwdriver until it comes completely off), remove the metal cover and you can lift the rope pulley up once the tension is released from the spring without disturbing the spring. Install new rope and reasemble.
Was this answer helpful?

Jim Dooley posted an answer 16 years, 1 month ago

5 Thanks for the help, I will give this a try
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual