1. Manuals
  2. Lawn and Garden Support
  3. Sears Support
  4. Pressure Washer Support
Support User Manuals
Question About Sears Pressure Washer 752880
Won't start even with gas/ oil/ clean air filter/ ...

Won't start even with gas/ oil/ clean air filter/ switched to ON/ no pressure in nozzle/ etc. 3 month old unit used for about 10 hours so far but not started in last 1.5 months. No choke or throttle control. Any suggestions?

Asked by on 10/07/2013 1  Answer

ManualsOnline posted an answer 11 years, 2 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

Rewarder User posted an answer 10 years, 9 months ago

5 After connecting your water supply (make sure it's supplying water to your water pump) try taking the air cleaner off and spraying a couple of bursts of a good quality starting fluid. The engine should run for a few seconds if not continuously. This will tell you if your motor is still OK. id it runs for seconds your carb needs cleaning, if it runs continuously your choke/ cold starting mechanism needs work (primer bulb, choke lever &/or choke linkage. a common operator error with pressure washers is the failure to supple water before the motor is fired up, which can lead to pump failure
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual